
58 Flix Engine Linux Module Documentation
Note:
Valid range: [0,63]
Default: Bits per pixel dependent
Attention:
Setting this value too low will likely cause the encoder to miss (i.e., overshoot) the target datarate
specified by FE2_VP6_BITRATE and, should FE2_VP6_TEMPORAL_RESAMPLING be enabled,
result in a large amount of dropped frames. The table mentioned above should be used as a guide in
choosing a reasonable value based on the bitrate.
Definition at line 149 of file vp6_alpha.h.
5.15.2.14 #define FE2_VP6A_MIN_Q
Alias for FE2_VP6_MIN_Q.
Codec parameter for minimum quantizer.
Determines the quality of the output. A lower minimum number produces higher quality output.
Note:
Valid range: [0,63]
Default: Bits per pixel dependent
Definition at line 138 of file vp6_alpha.h.
5.15.2.15 #define FE2_VP6A_NOISE_REDUCTION
Alias for FE2_VP6_NOISE_REDUCTION.
Codec parameter for noise reduction.
Determines the level of noise filtering to apply in the preprocessor. 0 is no preprocessing, 6 is extreme
preprocessing.
Note:
Valid range: [0,6]
Setting this value to anything but 0 will result in slowing down the compression speed.
Default: Bits per pixel dependent
Definition at line 115 of file vp6_alpha.h.
5.15.2.16 #define FE2_VP6A_RC_MODE
Alias for FE2_VCODECPARAM_RC_MODE.
Note:
Default: VBR_2PASSControl
Definition at line 92 of file vp6_alpha.h.
Generated on Tue Jul 20 17:39:03 2010 for Flix Engine Linux by Doxygen
Komentarze do niniejszej Instrukcji